CA3-CBLA-01 MITSUBISHI A/QnA series CPU PLC connection cable (5 m)

The module is used for mounting on the back board of the GLC2000 series host computer. Then you can install the GP77R series or GLC100 series of medium size expansion module in the module on the outward side.1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA3-CBLA-01. Used to display analog RGB (2 channels) on the GP3000Cable for transmitting an image signal from an Pro-face host to a Pro-face industrial display or other commercial display device (24- DVI-D pin convex) CA3-CBLA-01Touch screen anti ultraviolet protective film (1 pieces).15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1) CA3-CBLA-01. Note: joints A and B are different, the joints C and D different.Input / output hybrid I/O modules, including 16 point NPN/PNP input and 16 point NPN transistor outputThe main body module and the separate display module are used for connecting the main machine module and the separate display module in the DIN guide rail.Clock battery, save system date and time when power is off.12.1 inches, replaced by a host of backlight (1) CA3-CBLA-01. 15 inches, GP installed to the hard panel to provide dust and moisture proof function.7.4 inches, installed to provide the function of dust and moisture5 / sets7.4 inches, replace the backlight (1 / set)A1/A2/B+ DIO Type connector (compression type) (5 / set)The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.Input / output hybrid I/O modules, including 16 point NPN/PNP input and 16 point PNP transistor output10.4 inches (STN), the replacement of the host backllight (2 / set) CA3-CBLA-01. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connectorThe man-machine interface directly connected MITSUBISHI electric PLC QnA series A/ CPU programming port.Cable for connecting GP3000 to various modulesCOM1 interface with the cable (RS-232C), used to connect directly to the Q series connection module (or other host)