CA3-ADPTRM-01 User's Manual ()

12.1 inches, replaced by a host of backlight (1).7.5 inches /3.8 inches /5.7 inches, used to connect the power cord (5 / sets).Adapter for EX module (5 / set)Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM22GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA3-ADPTRM-01 User's Manual CA3-ADPTRM-01 Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communication cable. (5 / set)Used to connect the SIEMENS S5 PLC series to the host computer interfaceCOM1 interface with the cable for direct connection to the CPU series PLC AExtension cable for connecting USB (Type-A) interface to front panel CA3-ADPTRM-01 User's Manual. For 5.7 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)10.4 inches (TFT), the replacement of the host backlight (1).COM1 interface with the cable for direct connection to the CPU series PLC QProtection for GP rear connectors (large and small for each of the 1).12.1 inches /10.4 inches (STN), the GP installed to the hard panel to provide dust and moisture proof function CA3-ADPTRM-01 User's Manual. Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interface.512MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card.Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationCOM2 terminal adapter for communication through the RS-422/485 connectionCOM1 pin adapter, which is used to connect the communication components that are dedicated to the COOM2 interface to the COM1 interface of the man-machine interface CA3-ADPTRM-01 Manual. COM2 adapter for converting the COM2 interface to the RS-422 terminal blockCOM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-maachine interfaceThe main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module CA3-ADPTRM-01 Manual.